Over 15 years experience of providing support of MEAN WELL Power Supplies
Image shown is a representation only. Exact specifications should be obtained from the product datasheet.
Mean Well PSD-45C-5 DC-DC Converter - 45W - 36~72V in 5V out 9A
Overview
PSD-45C-5 is the 5V output model of this series: rated current 9A, rated power 45W, typical efficiency 80%.
Features
- 2:1 wide input range
- Protections:Short circuit/Over load /Over voltage/ Polarity
- Cooling by free air convection
- Built-in EMI filter, low ripple noise
- 100% full load burn-in test
- Fixed switching frequency at 96KHZ
- Low cost
- High reliability
- 2 year warranty
Specifications
OUTPUT
- DC VOLTAGE
- 5V
- RATED CURRENT
- 9A
- CURRENT RANGE
- 0 ~ 9A
- RATED POWER
- 45W
- RIPPLE & NOISE (max.)Note.2
- 100mVp-p
- VOLTAGE ADJ RANGE
- 4.5 ~ 5.5V
- VOLTAGE TOLERANCENote.3
- ± 2.0%
- LINE REGULATION
- ± 1.0%
- LOAD REGULATION
- ± 1.0%
- SETUP, RISE, HOLD UP TIME
- 1000ms, 50ms, ----/12VDC/24VDC at full load; 1500ms,50ms,----48VDC at full load
INPUT
- VOLTAGE RANGE
- 36~72VDC(48VDC)
- EFFICIENCY(Typ.)
- 80%
- DC CURRENT(Typ.)
- 3.5A/12VDC 2.5A/24VDC 1.2A/48VDC
PROTECTION
- OVER LOAD
- 105% -160% rated output power Protection type :shut down, Re-power on after fault condition is removed
- OVER VOLTAGE
- 5.75 ~ 6.75V/10%load Protection type : Hiccup mode, recovery automatically after fault condition is removed
ENVIRONMENT
- WORKING TEMP.
- -10 ~ +60℃ (Refer to output load derating curve),20~90%RH non-condensing
- WORKING HUMIDITY
- 20 ~ 95% RH non-condensing
- STORAGE TEMP., HUMIDITY
- -20 ~ +85℃, 10 ~ 95% RH
- TEMP. COEFFICIENT
- ±0.05%/℃ (0 ~ 50℃)
- VIBRATION
- 10 ~ 500Hz, 2G 10min./1cycle, Period for 60min.each along X, Y, Z axes
SAFETY & EMC
- SAFETY STANDARDS
- TUV BS EN/EN62368-1, EAC TP TC 004 approved
- WITHSTAND VOLTAGE
- I/P-O/P:1.5KVAC I/P-FG:2.0KVAC O/P-FG:0.5KVAC
- ISOLATION RESISTANCE
- I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC / 25℃/ 70% RH
- EMI CONDUCTION&RADIATION
- Compliance to BS EN/EN55032(CISPR32) CLASS B, EAC TP TC 020
- EMS IMMUNITY
- Compliance to BS EN/EN61000-4-2,3,4,6,8,BS EN/EN55035,BS EN/EN61000-6-1 Light industry level, EAC TP TC 020
OTHERS
- MTBF
- 3067.4K hrs min. Telcordia SR-332 (Bellcore) ; 463.9K hrs min. MIL-HDBK-217F (25℃)
- DIMENSION
- 127*76*30mm (L*W*H)
- PACKING
- 0.19Kg;72pcs/15.6Kg/1.28CUFT
Test conditions and notes5
- 1.All parameters NOT specially mentioned are measured at normal input,rated load and 25℃ of ambient temperature.
- 2.Ripple & noise are measued at 20 MHz of bandwidth by using a 12inch twisted pair-wire termined with a 0.1uf & 47uf capacitor.
- 3.Tolerance:includes set up tolerance,line regulation and load regulation.
- 4.The interval of turning ON and OFF the power supply continuously is 2 seconds.
- 5.The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).
Technical drawings
Downloads
FAQ
Can I use the PSD-45C-5 to derive 5V power from a 36-72V DC source for industrial electronics?
Yes, this model is intended to convert 36-72V input to a constant 5V output. It provides up to 9A output current with a total power rating of 45W.
Is the PSD-45C-5 suitable for 5V embedded controllers or communication hardware on a higher-voltage DC system?
It is a fit when the equipment needs regulated 5V DC and the available source is within the 36-72V input range. The output capacity is 45W, which corresponds to up to 9A at 5V.
Can this converter support higher-current 5V loads in automation or IT equipment?
Yes, within its rating it can support 5V loads up to 9A. That gives it more 5V output capacity than lower-power PSD models such as the 5W, 15W, 25W, or 30W versions.
Is the PSD-45C-5 appropriate for outdoor control boxes?
The published operating temperature range is -10°C to +60°C, but no IP rating is shown in the provided specs. That means temperature capability is stated, while outdoor ingress protection is not specified here.
How does the PSD-45C-5 compare with other PSD 45-series converters?
Among the related higher-output models, PSD-45A-5 is 30W at 5V and 6A, PSD-45A-12 is 30W at 12V and 2.5A, and PSD-45A-24 is 30W at 24V and 1.25A. The 45W options are PSD-45B-5 at 5V and 9A, PSD-45B-12 and PSD-45C-12 at 12V and 3.75A, and PSD-45B-24 and PSD-45C-24 at 24V and 1.875A; this unit is the 36-72V input, 5V, 9A version.
Payment & Security
Payment methods
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
Other PSD-45C Models
2 other models| Model | Power | Voltage | Current | IP Rating | Price | |
|---|---|---|---|---|---|---|
| Mean Well PSD-45C-24 DC-DC Converter - 45W - 36~72V in 24V out 1.875A | 45W | 24V | 1.875A | IP20 | $20.00 | View |
| Mean Well PSD-45C-12 DC-DC Converter - 45W - 36~72V in 12V out 3.75A | 45W | 12V | 3.75A | IP20 | $20.00 | View |
Please log in to write a review.
Write a review
Reviews are checked before publishing. By submitting you confirm this is your genuine experience with this product.
Submitting your review…
It's published and now helps other buyers.
We're checking it and it'll appear shortly.
Please try again.
