Over 15 years experience of providing support of MEAN WELL Power Supplies
Image shown is a representation only. Exact specifications should be obtained from the product datasheet.
Mean Well PS-05-24 Power Supply 5W 24V 220mA
Overview
PS-05-24 is the 24V output model of this series: rated current 0.22A, rated power 5.28W, typical efficiency 76%.
Features
- Universal AC input / Full range
- Low leakage current <0.5mA
- Protections: Short circuit / Overload / Over voltage / Over temperature
- Cooling by free air convection
- 100% full load burn-in test
- Fix switching frequency at 67KHz
- Low cost
- High reliability
- 2 years warranty
Specifications
OUTPUT
- DC VOLTAGE
- 24V
- RATED CURRENT
- 0.22A
- CURRENT RANGE
- 0 ~ 0.25A
- RATED POWER
- 5.28W
- RIPPLE & NOISE (max.)Note.2
- 200mVp-p
- VOLTAGE TOLERANCENote.3
- ±2.0%
- LINE REGULATION
- ±0.5%
- LOAD REGULATION
- ±0.5%
- SETUP, RISE TIME
- 1000ms, 20ms
- HOLD UP TIME(Typ.)
- 100ms at full load
INPUT
- VOLTAGE RANGE
- 85 ~ 264VAC 120 ~ 370VDC
- FREQUENCY RANGE
- 47 ~ 63Hz
- EFFICIENCY(Typ.)
- 76%
- AC CURRENT (Typ.)
- 0.15A/115VAC 0.07A/230VAC
- INRUSH CURRENT (Typ.)
- COLD START 30A/230VAC
- LEAKAGE CURRENT
- <0.5mA / 240VAC
PROTECTION
- OVERLOAD
- Above 105% rated output power Protection type : Hiccup mode, recovery automatically after fault condition is removed
- OVER VOLTAGE
- 27.6 ~ 32.4V
- OVER TEMPERATURE
- Hiccup mode, recovery automatically after fault condition is removed
ENVIRONMENT
- WORKING TEMP.
- -10 ~ +60℃ (Refer to "Derating Curve")
- WORKING HUMIDITY
- 20 ~ 90% RH non-condensing
- STORAGE TEMP., HUMIDITY
- -20 ~ +85℃, 10 ~ 95% RH
- TEMP. COEFFICIENT
- ±0.05%/℃ (0 ~ 50℃)
- VIBRATION
- 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY & EMC (Note 4)
- SAFETY STANDARDS
- TUV BS EN/EN62368-1,EAC TP TC 004 approved, IEC62368-1 CB approved by TUV
- WITHSTAND VOLTAGE
- I/P-O/P:3KVAC
- ISOLATION RESISTANCE
- I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH
- EMI CONDUCTION & RADIATION
- Compliance to BS EN/EN55032 (CISPR32) Class B, EAC TP TC 020
- HARMONIC CURRENT
- Compliance to BS EN/EN61000-3-2,-3
- EMS IMMUNITY
- Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11, BS EN/EN55035, light industry level, EAC TP TC 020
OTHERS
- MTBF
- 6873.2K hrs min. Telcordia SR-332 (Bellcore) ; 1271.1K hrs min. MIL-HDBK-217F (25℃)
- DIMENSION
- 75*40*20mm (L*W*H)
- PACKING
- 0.05Kg; 120pcs/6.25Kg/0.56CUFT
Test conditions and notes5
- 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
- 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1μF & 47μF parallel capacitor.
- 3. Tolerance : includes set up tolerance, line regulation and load regulation.
- 4. The power supply is considered a component which will be installed into a final equipment. All the EMC tests are been executed by mounting the unit on a 360mm*360mm metal plate with 1mm of thickness. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to “EMI testing of component power supplies.” (as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf )
- 5. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).
Technical drawings
Downloads
FAQ
Can I use the PS-05-24 for a small 24V industrial sensor or transmitter?
Yes, this model is designed for constant-voltage 24V output and can support low-power industrial or automation loads that stay within 5.28W and 0.22A. It is better suited to a single small 24V device or similarly light control load than to multi-device circuits.
Is the PS-05-24 suitable for a compact 24V PLC or control interface module?
It can be a fit for a compact 24V control or interface module if that device's draw does not exceed 0.22A at 24V. With 5.28W total output capacity, it is intended for light-duty embedded and automation electronics rather than higher-load control hardware.
Can this 24V power supply run a small embedded automation board?
Yes, if the board requires a regulated 24V constant-voltage input and its total demand stays under 5.28W and 0.22A. That makes it appropriate for low-power embedded control tasks where the load is modest and stable.
Would the PS-05-24 work for a low-current 24V relay or signaling application?
It can work for low-current 24V relay, signaling, or interface uses when the total load remains within 24V, 0.22A, and 5.28W. For anything beyond that range, a higher-capacity 24V supply is needed, as the PS-05-24 is the only 24V model in the 5W PS-05 series.
Is the PS-05-24 rated for outdoor or harsh-environment use?
The listed specs provide an operating temperature range of -10°C to +60°C, but no IP rating is provided. Based on the published data alone, it is suitable only for environments that stay within that temperature range, and outdoor or exposed-condition suitability is not established.
How does the PS-05-24 compare with the other PS-05 power supplies?
Within the PS-05 family, the PS-05-5 is 5W, 5V, 1A; the PS-05-12 is 5.4W, 12V, 0.45A; the PS-05-15 is 5.25W, 15V, 0.35A; the PS-05-24 is 5.28W, 24V, 0.22A; and the PS-05-48 is 5.28W, 48V, 0.11A. The main difference across these sibling models is the output voltage and corresponding output current within the same compact 5W class.
Payment & Security
Payment methods
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
Other PS-05 Models
4 other models| Model | Power | Voltage | Current | IP Rating | Price | |
|---|---|---|---|---|---|---|
| Mean Well PS-05-5 Power Supply 5W 5V 1A | 5W | 5V | 1A | IP20 | $7.18 | View |
| Mean Well PS-05-48 Power Supply 5W 48V 110mA | 5.28W | 48V | 0.11A | IP20 | $7.21 | View |
| Mean Well PS-05-15 Power Supply 5W 15V 350mA | 5.25W | 15V | 0.35A | IP20 | $7.21 | View |
| Mean Well PS-05-12 Power Supply 5W 12V 450mA | 5.4W | 12V | 0.45A | IP20 | $7.18 | View |
Please log in to write a review.
Write a review
Reviews are checked before publishing. By submitting you confirm this is your genuine experience with this product.
Submitting your review…
It's published and now helps other buyers.
We're checking it and it'll appear shortly.
Please try again.
