Over 15 years experience of providing support of MEAN WELL Power Supplies
Image shown is a representation only. Exact specifications should be obtained from the product datasheet.
Mean Well ELG-200-48AB Power Supply 200W 48V - Adjustable and Dimmable
The ELG-200 is a 200W Mean Well power converter (input range: 100~305VAC).
Key Features
- ✓ Input voltage range: 100~305VAC
- ✓ DC output voltage adjustable ±10%
- ✓ 3.75KVAC reinforced I/O isolation
- ✓ Protections: Short circuit / Over voltage / Over temperature
- ✓ Active PFC — meets international energy efficiency regulations
- ✓ Safety approvals: (type”HL”), CSA C22.2 No. 250.13-12;IEC/EN/AS/NZS 61347-1, IEC/EN/AS/NZS 61347-2-13 UL8750 EAC TP TC 004;BIS IS15885(for 12/12B/24/24B/36/36A/42A/48/48A/54A only) GB19510.14,GB19510.1; IP65 or IP67; KC61347 1 KC61347 2 13
- ✓ 3 years warranty
-
BrandMean Well
-
SeriesELG Series
-
Power Rating199.68 Watt
-
Output Voltage48 Volt
-
Rated Current4.16 Ampere
-
Input Voltage100V~305V
-
No of Output1
-
Dimming Control0-10V,10V PWM,Resistance
-
Standards MetBSI,CB,CCC,CE,EAC,ENEC,KC,RCM,UL
-
Operation ModeConstant Current,Constant Voltage
-
Operating Temperature-40°C~90°C
-
Warranty5 Year
-
Length9.61 in
-
Width2.8 in
-
Height1.48 in
-
Weight2.69 lb
::specification::
Frequently Asked Questions
Can I use the ELG-200-48AB to power a large 48V LED strip installation?
Yes. The ELG-200-48AB delivers up to 199.68W at 48V, making it suitable for powering 48V LED strip runs. At 199.68W total, you can support strips drawing up to that wattage — check your strip's rated power per meter to calculate the maximum run length (e.g., a 14W/m strip allows roughly 14 meters from a single driver). The adjustable output lets you fine-tune voltage between 24V and 48V if your strip requires a slightly different setpoint.
Is the ELG-200-48AB suitable for outdoor architectural lighting or building facade signage?
The ELG-200-48AB carries an IP65 water-resistance rating, meaning it is protected against low-pressure water jets from any direction. It is suitable for covered outdoor locations such as under-eave signage cabinets, outdoor lighting enclosures, or facade lighting channels where the driver is not submerged or directly rain-exposed. For fully exposed or submerged applications, the IP67-rated ELG-200-48B would be a better fit.
Can I dim the ELG-200-48AB with a standard 0-10V dimming controller?
Yes. The AB suffix indicates this driver supports both output voltage adjustment (via a trimmer pot over the 24–48V CC range) and three-in-one dimming: 1–10V analog, PWM signal, or resistance-based control. You can pair with a 0–10V controller directly to its dimming interface to smoothly adjust light output.
Can the ELG-200-48AB be used in a retail display cabinet with continuous operation?
Yes. The driver is rated for an operating temperature range of -40°C to +90°C and carries a 5-year warranty, indicating it is designed for continuous-duty commercial use. Its metal case aids heat dissipation, making it appropriate for enclosed retail display cabinets with 48V LED lighting.
What certifications does the ELG-200-48AB hold, and can it be used in North American installations?
The ELG-200-48AB holds c_BSI, CB, CCC, CE, EAC, ENEC, KC, c_RCM, and UL certifications. The UL and c_BSI listings confirm it meets requirements for use in North American electrical installations where UL-listed equipment is specified.
How does the ELG-200-48AB differ from the ELG-200-48B?
Both are 199.68W, 48V, 4.16A drivers in the same enclosure. The key differences are: the ELG-200-48AB is IP65 water-resistant and includes output voltage adjustment plus three-in-one dimming; the ELG-200-48B is IP67 waterproof and supports three-in-one dimming without a voltage trimmer. Choose the AB if you need to fine-tune the output voltage; choose the B if the installation demands the higher IP67 ingress protection.
Is the ELG-200-48AB appropriate for powering LED strip lighting in a food-service or commercial kitchen environment?
The IP65 rating protects against water jets and steam splash, so the ELG-200-48AB can be installed in a commercial kitchen if mounted in a dry, ventilated area away from direct spray. For environments where the driver may be exposed to direct hose-down cleaning, the IP67-rated ELG-200-48B offers a higher margin of protection.
Payment & Security
Payment methods
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
Other ELG-200 Models
7 other models| Model | Power | Voltage | Current | IP Rating | Price | |
|---|---|---|---|---|---|---|
| Mean Well ELG-200-24DA Power Supply 200W 24V - DALI | 201.6W | 24V | 8.4A | IP67 | $56.01 | View |
| Mean Well ELG-200-24B Power Supply 200W 24V - Dimmable | 201.6W | 24V | 8.4A | IP67 | $53.51 | View |
| Mean Well ELG-200-24 Power Supply 200W 24V | 201.6W | 24V | 8.4A | IP67 | $51.37 | View |
| Mean Well ELG-200-12 Power Supply 192W 12V | 192W | 12V | 16A | IP67 | $49.88 | View |
| Mean Well ELG-200-12A Power Supply 192W 12V 3-wire Input - Adjustable | 192W | 12V | 16A | IP65 | $51.37 | View |
| Mean Well ELG-200-12-3Y AC-DC Single output LED Driver Mix Mode (CV+CC) with PFC | 200W | 12V | 16A | IP67 | $59.29 | View |
| Mean Well ELG-200-C1050A Power Supply 200W 1050mA - Adjustable | 199.5W | 200V | 1.05A | IP65 | $56.25 | View |
Please log in to write a review.
Write a review
Reviews are checked before publishing. By submitting you confirm this is your genuine experience with this product.
Submitting your review…
It's published and now helps other buyers.
We're checking it and it'll appear shortly.
Please try again.
